Cranborne Audio N22H

Deployable Headphone Amps via Cat 5

N22H is a headphone amp that can be deployed exactly where it is needed - right beside the musician.

Using our C.A.S.T. system, N22H can be connected on the end of a 100m (330ft) shielded Cat 5e, Cat 6, and Cat 7 cable and deliver a headphone mix directly to the musician during tracking.

Standalone Reference-Quality Amplification

Based on the same custom design found in the renowned 500R8 interface, N22H’s headphone amplifier achieves a flat Frequency Response from 0.8Hz to above 250kHz and ultra-low distortion (0.0009% THD+N, 100 kOhm load) allowing it to power headphones with clean, transparent power during critical listening, mixing, and mastering.

Key features

• Two balanced combi jack inputs
• Two balanced XLR and 1/4” jack outputs
• Reference-quality headphone amplifier
• Switchable High and Low Power Modes
• 9V Battery compartment
• 9V DC Power Inlet
• C.A.S.T IN RRTT Port
• C.A.S.T OUT TTRR Port
• Cat5 snake connectivity with N22 or second N22H
• Compatible with any shielded Cat 5e/Cat 6/Cat 7 cable with distances up to 100m/330ft
• Improved crosstalk performance with high-performance Cat 6 and Cat 7 (recommended)
• Ruggedised metal enclosure
• Fixing holes for permanent installation
• Cable-tie holes for cable management
• Non-slip rubber feet
• ⅜” mic stand thread mount on bottom